Time limit: 0
Quiz Summary
0 of 9 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Quiz complete. Results are being recorded.
Results
0 of 9 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you didn’t pass the quiz, but hey, you have unlimited access.😎
Practice makes you perfect! 👊 -
Congratulations! 🥳
You have passed the quiz successfully! You are one step closer to pass the real exam!
We hope to see you again on another certification path.✌️
Good luck with the exam! Stay strong.👊
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 9
1. Question
Which of the following protocols synchronize the time of different systems?
CorrectIncorrect -
Question 2 of 9
2. Question
Type the command that states whether the Cisco Discovery Protocol (CDP) is enabled globally.
-
SW-examsdigest#
CorrectIncorrect -
-
Question 3 of 9
3. Question
Examine the following show command output on a router configured for dynamic NAT:
— Inside Source
access-list 1 pool examsdigest
pool examsdigest: netmask 255.255.255.240
start 190.1.1.1 end 190.1.1.10
type generic, total addresses 10, allocated 10 (100%), misses 595You are responsible to find out why users are not being able to reach the Internet.
CorrectIncorrect -
Question 4 of 9
4. Question
Given the diagram below, complete the missing configuration command in order to make the static NAT functional.
-
R1# show running-config
! Lines omitted for brevity!
interface FastEthernet0/0
ip address 192.168.1.3 255.255.255.0
ip nat inside
!
interface GigabitEthernet0/0
ip address 190.2.2.21 255.255.255.0
!
ip nat inside source static 192.168.1.2 200.1.1.2
ip nat inside source static 192.168.1.1 200.1.1.1
CorrectIncorrect -
-
Question 5 of 9
5. Question
Given the following configuration command outputs. Match the Network Address Translation methods (PAT or Dynamic NAT) with the respective configuration commands.
Sort elements
- PAT
- DNAT
-
ExamsDigestR1# show running-config
interface GigabitEthernet0/0
ip address 192.168.1.3 255.255.255.0
ip nat inside
interface Serial0/0/0
ip address 100.1.1.249 255.255.255.252 ip nat outside
ip nat inside source list 1 interface Serial0/0/0 overload
access-list 1 permit 192.168.1.2
access-list 1 permit 192.168.1.1
-
ExamsDigestR2# show running-config
interface GigabitEthernet0/0
ip address 192.168.1.3 255.255.255.0
ip nat inside
interface Serial0/0/0
ip address 100.1.1.251 255.255.255.0
ip nat outside
ip nat pool examsdigest 100.1.1.1 100.1.1.2 netmask 255.255.255.252
ip nat inside source list 1 pool examsdigest
access-list 1 permit 192.168.1.2
access-list 1 permit 192.168.1.1
CorrectIncorrect -
Question 6 of 9
6. Question
Which of the following characteristics of network traffic can be managed by Quality of Service (QoS)? (Choose all that apply)
CorrectIncorrect -
Question 7 of 9
7. Question
Match the Cisco QoS toolsets with the respective description.
Sort elements
- Classification and Marking
- Queuing
- Shaping and Policing
- Congestion Avoidance
-
QoS categorize packets by examining the contents of the frame, and packet headers, and change the packet headers
-
QoS allows you to control congestion by determining the order in which packets are sent out an interface based on priorities assigned to those packets
-
QoS monitors the bit rate of the messages that flow through a device.
-
QoS attempts to reduce overall packet loss by preemptively discarding some packets used in TCP connections.
CorrectIncorrect -
Question 8 of 9
8. Question
R1 and R2 are attached to the same Ethernet VLAN, with subnet 192.168.1.0/24, and addresses 192.168.1.1, 192.168.2 respectively. The routers use an FHRP. Host A and host B attach to the same LAN and have correct default router settings per the FHRP configuration. Which of the following statements is true for this LAN?
CorrectIncorrect -
Question 9 of 9
9. Question
One of the features of SNMPv3 is called message integrity.
CorrectIncorrect